Instalei em uma rede um Suse, que é o único servidor da rede. Um servidor para distribuir a internet. Configurei o SuseFirewall como abaixo. Mas a internet ficou lenta e ninguem consegue usar o Outlook.
O que fazer??
FW_QUICKMODE="no"
FW_DEV_EXT="eth-id-00:e0:7d:e6:a3:1f"
FW_DEV_INT=" eth-id-00:e0:7d:d2:21:1b eth-id-00:02:44:0d:c7:69 eth-id-00:e0:7d:d2:20:f8"
FW_DEV_DMZ=""
FW_ROUTE="yes"
FW_MASQUERADE="yes"
FW_MASQ_DEV="$FW_DEV_EXT"
FW_MASQ_NETS="0/0"
FW_PROTECT_FROM_INTERNAL="no"
FW_AUTOPROTECT_SERVICES="no"
FW_SERVICES_EXT_TCP=""
FW_SERVICES_EXT_UDP="" # Common: domain
FW_SERVICES_EXT_IP=""
FW_SERVICES_EXT_RPC=""
FW_SERVICES_DMZ_TCP=""
FW_SERVICES_DMZ_UDP=""
FW_SERVICES_DMZ_IP=""
FW_SERVICES_DMZ_RPC=""
FW_SERVICES_INT_TCP=""
FW_SERVICES_INT_UDP=""
FW_SERVICES_INT_IP=""
FW_SERVICES_INT_RPC=""
FW_SERVICES_QUICK_TCP=""
FW_SERVICES_QUICK_UDP=""
FW_SERVICES_QUICK_IP=""
FW_TRUSTED_NETS=""
FW_ALLOW_INCOMING_HIGHPORTS_TCP="no"
FW_ALLOW_INCOMING_HIGHPORTS_UDP="DNS"
FW_SERVICE_AUTODETECT="yes" # Autodetect the services below when starting
FW_SERVICE_DNS="no"
FW_SERVICE_DHCLIENT="no"
FW_SERVICE_DHCPD="no"
FW_SERVICE_SQUID="no"
FW_SERVICE_SAMBA="no"
FW_FORWARD="" # Beware to use this!
FW_FORWARD_MASQ="" # Beware to use this!
FW_REDIRECT=""
FW_LOG_DROP_CRIT="yes"
FW_LOG_DROP_ALL="no"
FW_LOG_ACCEPT_CRIT="yes"
FW_LOG_ACCEPT_ALL="no"
FW_LOG=""
FW_KERNEL_SECURITY="yes"
FW_ANTISPOOF="no"
FW_STOP_KEEP_ROUTING_STATE="no"
FW_ALLOW_PING_FW="yes"
FW_ALLOW_PING_DMZ="no"
FW_ALLOW_PING_EXT="no"
FW_ALLOW_FW_TRACEROUTE="yes"
FW_ALLOW_FW_SOURCEQUENCH="yes"
FW_ALLOW_FW_BROADCAST="int"
FW_IGNORE_FW_BROADCAST="no"
FW_ALLOW_CLASS_ROUTING="no"
FW_CUSTOMRULES=""
FW_REJECT="no"
FW_HTB_TUNE_DEV=""
FW_IPv6=""
FW_IPv6_REJECT_OUTGOING="yes"
FW_IPSEC_TRUST="no"
FW_IPSEC_MARK=""
Tópico: Susefirewall como configurar? (Lida 2220 vezes)